About Hdmi - Pioneer SC-LX83 Guide Rapide

Connecting your equipment
If several video components are assigned to the same
input function (see The Input Setup menu on Operating
Instructions in CD-ROM), the converter gives priority to
HDMI, component, then composite (in that order).
Terminal for connection
with source device
HDMI IN
Y P P
B R
COMPONENT
VIDEO IN
VIDEO IN
Video signals can be output
• For optimal video performance, THX recommends
switching Digital Video Conversion (in Setting the
Video options on Operating Instructions in CD-ROM)
OFF.
This product incorporates copyright protection technology that is
protected by U.S. patents and other intellectual property rights.
Use of this copyright protection technology must be authorized by
Rovi Corporation, and is intended for home and other limited
viewing uses only unless otherwise authorized by Rovi
Corporation. Reverse engineering or disassembly is prohibited.
Note
1 • An HDMI connection can only be made with DVI-equipped components compatible with both DVI and High Bandwidth Digital Content
Protection (HDCP). If you choose to connect to a DVI connector, you will need a separate adaptor (DVIHDMI) to do so. A DVI connection,
however, does not support audio signals. Consult your local audio dealer for more information.
• If you connect a component that is not compatible with HDCP, an HDCP ERROR message is displayed on the front panel display. Some
components that are compatible with HDCP still cause this message to be displayed, but so long as there is no problem with displaying video
this is not a malfunction.
• Depending on the component you have connected, using a DVI connection may result in unreliable signal transfers.
• This receiver supports SACD, Dolby Digital Plus, Dolby TrueHD and DTS-HD Master Audio. To take advantage of these formats, however,
make sure that the component connected to this receiver also supports the corresponding format.
®
2 • Use a High Speed HDMI cable. If an HDMI cable other than a High Speed HDMI
• When an HDMI cable with a built-in equalizer is connected, it may not operate properly.
3 Signal transfer is only possible when connected to a compatible component.
4 • HDMI format digital audio transmissions require a longer time to be recognized. Due to this, interruption in the audio may occur when
switching between audio formats or beginning playback.
• Turning on/off the device connected to this unit's HDMI OUT terminal during playback, or disconnecting/connecting the HDMI cable during
playback, may cause noise or interrupted audio.

About HDMI

The HDMI connection transfers uncompressed digital
video, as well as almost every kind of digital audio.
Terminal for connection
with TV monitor This receiver incorporates High-Definition Multimedia
Interface (HDMI
This receiver supports the functions described below
HDMI OUT
through HDMI connections.
Y P P
B R
COMPONENT VIDEO
MONITOR OUT
VIDEO
MONITOR OUT
HDMI, the HDMI logo and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing, LLC in the United States and other countries.
"x.v.Color" and x.v.Color logo are trademarks of Sony
Corporation.
1
®
) technology.
• Digital transfer of uncompressed video (contents
protected by HDCP (1080p/24, 1080p/60, etc.))
3
• 3D signal transfer
• Deep Color signal transfer
3
• x.v.Color signal transfer
3
• Audio Return Channel
• Input of multi-channel linear PCM digital audio
signals (192 kHz or less) for up to 8 channels
• Input of the following digital audio formats:
– Dolby Digital, Dolby Digital Plus, DTS, High bitrate
audio (Dolby TrueHD, DTS-HD Master Audio, DTS-
HD High Resolution Audio), DVD-Audio, CD, SACD
(DSD signal), Video CD, Super VCD
• Synchronized operation with components using the
Control with HDMI function (see Control with HDMI
function on Operating Instructions in CD-ROM).
®
cable is used, it may not work properly.
2
3
4
02
19
En