Joerns Oxford 4-Point Adaptive Power Cradle Manuel De L'utilisateur page 5

Oxford
®
English
Adaptive Power Cradle
CAUTION: Prior to removing the quick release pin, the cradle needs to be supported by a
stationary object such as a workbench or table. This will prevent the cradle from dropping
suddenly which could result in an injury or damage to the cradle.
Connection:
To connect, raise the 4-point Adaptive Power Cradle up towards the boom slot. Insert the pin
sleeve through lift boom, the black plastic end cap* and the cradle king pin. Once the pin sleeve
has been installed and is supporting the weight of the Adaptive Power Cradle, re-insert the quick
release pin fully into the sleeve until it locks into position (See fig. 6).
Black Plastic Caps
Fig. 6 Fig. 7
To verify that the pin is securely fitted, press your finger into the barbed end. If the pin remains
stationary, the lift is safe to use (See fig. 7).
WARNING!
YOU MUST CHECK THAT THE PIN IS SECURELY FITTED; a noticeable "click" will sound
when the connection has been made secure.
*Ensure you use the correct version of the black plastic cap for your lift, as 2 are supplied.
Check the cap width against your lifts boom before fitting.
5