Schaudt LAS 1218-2 Notice D'utilisation Et De Montage page 25

Flat vehicle fuses
810.523 BA / EN
Heruntergeladen von manualslib.de
Instruction Manual and Installation Instructions LAS 1218-2
Use a thin object (e.-g.- a ballpoint pen cartridge) to move the battery selec-
tor switch.
Suitability must be checked on a case-by-case using specifications from
Y
the battery supplier and the charging parameters of Schaudt equipment.
The charging parameters are specified in the operating and installation
instructions.
Setting lead gel battery: Set the battery selector switch to "Lead-gel".
Setting lead acid battery: Set the battery selector switch to "Lead-acid".
If the battery charger is used to supply 12V consumers without connec-
ted battery with power, the battery selector switch must be set to "Lead-
acid".
The indicator lamps on the front of the battery charger show the current
charging phase.
Main charge
This indicator lamp lights up yellow in the "Hauptladen" (Main charge) phase.
This indicator lamp lights up yellow in the "Vollladen" (Full charge) phase.
Full charge
Trickle charge This indicator lamp lights up green in the "Erhaltungsladen" (Trickle charge)
phase.
If the batteries are totally discharged, indicator lamp "Erhaltungsladen"
Y
(Trickle charge) or "Volladen" (Full charge) may light up for a while before
the main charging phase begins.
1.3.2 System faults
A fault in the power supply system is usually caused by a blown fuse.
Please contact our customer service department if you are unable to rectify
the fault using the following table.
If this is not possible, e.g. if you are abroad, you can have the battery char-
ger repaired at a specialist workshop. Please note that the warranty beco-
mes void if incorrect repair work is carried out. Schaudt GmbH cannot ac-
cept liability for any damages resulting from such repairs.
Handbücher-Suchmachiene
Date: 06.11.2014
5