Setup; Loose Parts; Unfolding The Handle - Toro SnowMaster 724 ZXR Mode D'emploi

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1

Unfolding the Handle

No Parts Required
Procedure
Important: Ensure the cables are not pinched when
unfolding the handle.
Description
No parts required
Bolt (1/4-20 X 1–1/2 inches)
Washer-faced locknut (1/4-20 inch)
No parts required
No parts required
Figure 4
Qty.
–
Unfold the handle.
1
Install the discharge chute.
1
–
Check the engine-oil level.
–
Check the tire pressure.
5
Use