Chapter 2 Installation And Connections; Installation; Hard Disk Installation - TKH TR0802P Guide De Démarrage Rapide

EN
Chapter 2 Installation and Connections
2.1 Installation
During installation of the NVR :
Use brackets for rack mounting.

Ensure ample room for audio and video cables.

When routing cables, ensure that the bend radius of the cables are no less than five times than its diameter.

Connect the alarm cable.

Allow at least 2cm (≈0.75‐inch) of space between racks mounted devices.

Ensure the NVR is grounded.

Environmental temperature should be within the range of ‐10 to +55º C (+14 to +131º F).

Environmental humidity should be within the range of 10% to 90%.

2.2 Hard Disk Installation
Before you start:
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory recommended HDD should be
used for this installation.
Tools Required: Screwdriver.
Purpose:
The following section introduces the HDD installation for the TRxx02P NVR.
Step 1 Remove the cover from the NVR by unfastening the screws on the rear and side panel.
Step 2 Connect one end of the data cable to the motherboard of NVR and the other end to the HDD.
Quick start guide - Network Video Recorder - TR0802P & TR1602P
Network Video Recorder Quick Start Guide
Figure 2‐1 Remove Cover
8
8