Black & Decker REVDS12C Traduction De La Notice D'instructions Originale page 7

The integral battery should be left connected to the charger
and the charger will begin to charge automatically when the
cell temperature warms up or cools down.
Insert the charging connector (4) into the charging port (5).
u
Plug in the charging connector (4).
u
Leave the tool connected to the charger for around 4
u
hours.
The charging indicator will illuminate during charging.
u
Assembly
Warning! Before assembly, make sure that the tool is
switched off.
Fitting sanding sheets (Fig. C )
Attach a sanding sheet (6) by pressing the 'hooked' velcro
u
side to the 'looped' velcro underside of the sanding base
(3).
Use
Warning! Let the tool work at its own pace. Do not overload.
Switching on and off
To switch the tool on, depress the on/off switch (1) at the
u
position I.
To switch the tool off, depress the on/off switch (1) at the
u
position O.
Maintenance
Your tool has been designed to operate over a long period of
time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance, switch off.
Regularly clean the ventilation slots in your tool using a
u
soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Protecting the environment
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be recov-
ered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
(Original instructions)
Technical data
Input voltage V
No - load speed
OPM
Oscilating angle
°
Sanding base surface mm
Weight kg
Integral Battery
Battery type
Ah rating
Charger
Input Voltage V
AC
Output voltage
V
DC
Current mA
Approx. charge time h
Level of sound pressure according to EN62841:
L (sound pressure) 68.5 dB(A), Uncertainty (K) 3 dB(A)
pA
L (sound power) 79.5 dB(A), Uncertainty (K) 3dB(A)
WA
Vibration total values (triax vector sum) according to EN 62841:
Vibration emission value (handle) (a
Declaration of conformity
The Supply of Machinery (Safety)
Regulations 2008
Orbital sander - REVDS12C
BLACK+DECKER declares that these products described
under "technical data" are in compliance with:
The Supply of Machinery (Safety) Regulations, 2008, S.I.
2008/1597 (as amended).
EN62841-1:2015, EN62841-2-4:2014.
These products conform to the following UK Regulations:
Electromagnetic Compatibility Regulations, 2016,
S.I.2016/1091 (as amended).
The Restriction of the Use of Certain Hazardous Substances
in Electrical and Electronic Equipment Regulations 2012, S.I.
2012/3032 (as amended).
For more information, please contact BLACK+DECKER at the
following address or refer to the back of the manual.
ENGLISH
REVDS12C
dc
2
S010**1400040
) 3.5 m/s , uncertainty (K) 1,5 m/s
2
h
12
11000
2.8
5078
0.862
Li-Ion
1.5
230
10.8
400mA
4
2
7