BALDR B0360WST2H2PR-V2 Mode D'emploi page 23

"ALERTS"buttons simultaneously to enter into indoor temperature
and humidity/barometer value calibration mode.
/MEM'' button to adjust the value.
3. Press and hold "
clear the calibration values.
Problem
Outdoor reading is
flashing or
showing dashes
No outdoor
sensor reception
" button before powering the weather stationto
TROUBLE SHOOTING
Possible Solution
Flashing of the outdoor reading is generally
an indication of wireless interference.
1. Bring both the sensor and display indoors,
side by side and remove batteries from
each.
2. Make sure the 1-2-3 switch on both units
match.
3. Reload batteries in main unit.
4. Reload batteries in outdoor sensor.
5. Let both units sit within a couple feet of
each other for a few minutes to gain a
strong connection before taking sensor to
outdoor area.
and main unit. Please refer to the SENSOR
SETUP section.
sensor. The units must be within 328 ft
(100 m) of each other.
23
or