Worx WT344 Notice Originale page 12

7. USING THE VARIABLE SPEED
CONTROL (See Fig. D)
The speed increases as you turn the switch
towards the higher number and decreases on
the lower number.
8. HAMMER DRILL FUNCTION (See Fig.
E, F)
1)For drilling concrete, masonry etc, press the
lock button (A) and rotate the selector switch
to make sign "
(See Fig. E)
NOTE: You must press the selector switch lock
button before adjusting the selector switch. If
the selector switch cannot go into the required
position, switch on your hammer a little, then
adjust the selector switch again.
2)Turn the hammer or drilling action selector
switch pointing to the hammer action "
position. (See Fig. F)
3)You are now set up for hammer drilling into
masonry.
9. DRILLING FUNCTION (See Fig. G, H)
1)Press the lock button (A) and rotate the
selector switch to make sign "
12
the triangle. (See Fig. G)
2)Turn the hammer or drilling action selector
switch pointing to the drilling action " "
position. (See Fig. H)
3)You are now set up for drilling function.
10. CHISEL FUNCTION (See I, J)
1)For chipping, grooving or demolition
operation, press the lock button (A) and then
rotate the selector switch make sign "
pointing to the triangle. (See Fig. I)
2)Turn the hammer or drilling action selector
switch pointing to the hammer action "
position. (See Fig. J)
3)You are now set up for chisel work using
Chisel action.
WARNING: You must make sure that
the selector switch is positively
locked in chisel mode position. If not, it
could cause a hazard.
11. DUST COVER (See Fig. K)
Use the dust cover to prevent dust from
falling over the tool and on your self when
performing overhead drilling operations.
Rotary hammer
" point to the triangle.
" point to
Attach the dust cover to the bit as shown in
the K.
12. LUBRICATION MACHINE (See Fig. L)
The machine is grease-lubricated. A grease
refill is only required during hammer work
efficiency is low. Open the grease box lid
at the top of the hammer using the pin
spanner provided. Then refill approx 30g
grease provided with your tool. The grease
specification is general purpose lithium based.
Use only Worx genuine hammer grease
(optional accessory).
CAUTION: Keep the container of grease
away from children.
13. TO REPLACE THE BRUSHES
(See Fig. M, N)
Disconnect the plug from the power supply.
"
Unscrew the carbon brush cap with
screwdriver.
Remove the carbon brush. Check the length
of the brush and replace if under 6mm. When
brushes need replacement always renew both
brushes, even if one is still more than 6mm
long.
Completely screw down the carbon brush cap.
Check that the tool is working. Before use,
allow it run for a few minutes to enable the
brushes to settle.
WORKING HINTS FOR
YOUR TOOL
"
1. Reduce the pressure on the drill bit when it
is about to break through. This will prevent
the drill from jamming.
"
2. When drilling a large hole, first drill a pilot
hole using a smaller drill bit.
3. Always apply pressure to your drill bit in a
straight line, and if possible at right angles
to the workpiece.
4. Never change the operating mode whilst
the drill is running.
5. Do not apply excessive pressure to the tool
when chiseling. Expressive force does not
speed up the work.
EN