Publicité
Les langues disponibles
Les langues disponibles
Network Type
Network type can be selected as Wired or Wireless
device, in accordance with the active connection to the
TV set. Select this as Wired if you have connected to
the TV a LAN cable. Select as Wireless if you connect
via the wireless USB dongle.
Configuration Status
This section displays the status of the connection.
Select Connected if you want to activate connection.
Select as Not Connected to end an active connection.
IP Address
If an active connection is available, the IP address will
be displayed on this section. If you want to configure
IP address preferences, press GREEN button and
switch to the advanced mode.
Configuring Wired Network Settings in
Advanced Mode
After pressing GREEN button, Advanced mode will
be available. While in Advanced Mode, press RED
button to edit settings. When finished, press OK to
save, Press RETURN/BACK to cancel.
Configuring Wireless Device Settings
(Optional)
IMPORTANT: "Veezy 200" USB dongle is required to
use wireless network feature. To use your TV with your
wireless network, you need a "Veezy 200" Wireless
USB dongle.
Wi-Fi feature can be used for a wireless network
connection. The feature is used for infrastructure
purposes only, such as connecting to the web, hbb
sites and connecting with DLNA servers (optional). If
you have the Veezy 200 Wifi Dongle, select Network
Type as Wireless Device to start connection process.
To enable Wi-Fi feature, profiles should be configured
properly. Please plug in the Wi-Fi dongle to one of the
USB ports.
Press YELLOW button to scan wireless network from
network settings menu. Afterwards, available network
list will be displayed. Please select your desired
network from the list.
Note: If the modem supports N mode, you should
prefer N mode settings.
If the selected network is protected with a password,
please enter the correct key by using the virtual
keyboard. You can use this keyboard via navigation
buttons (Left/Right/Up/Down) and OK button on the
remote control.
Wait until the IP the address is shown on the screen.
This means that the connection is now established.
To disconnect from a wireless network, you should
highlight Configuration Status and press OK.
English - 53 -
Publicité
