Bosch PEX 420 AE Instructions D'emploi page 8

Product Specifications
Eccentric Sander
Order number
Rated input power
Power output
No-load speed (reduced)
Stroke rate at no load
Speed selection
Eccentricity
Sanding plate dia.
Weight (without
accessories) approx.
Protection class
Please observe the order number of your machine.
The trade names of the individual machines may vary.
Noise/Vibration Information
Measured values determined according to EN 50 144.
The A-weighted sound pressure level of the product is
typically 71 dB(A). The noise level when working can
exceed 85 dB(A).
Wear ear protection!
The typically weighted acceleration is 3.5 m/s
Product Elements
1 L-type Allen key
2 Speed selector thumbwheel
3 Dust box (micro-filtersystem)
4 Locking button for On-off switch
5 On-off switch
6 Groove for suction hood
7 Suction hood
8 Screw
9 Sanding sheet*
10 Sanding plate
11 Auxiliary Handle
12 Winged screw for auxiliary handle adjustment
13 Holder
14 Plastic slide
15 Outlet piece
16 Latching lever
17 Filter element (micro-filtersystem)
18 Extraction adapter*
* Not all the accessories illustrated or described are in-
cluded in standard delivery.
2 609 932 214 • (03.02) T
PEX 420 AE
0 603 298 6..
[W] 420
[W] 250
[RPM] 2000
[RPM] 5000–16000
G
[mm] 5.0
[mm] 150
[kg] 1.9
/ II
2
.
English–1
Intended Use
The machine is intended for dry sanding of wood, plas-
tic, metal and filler material as well as painted surfaces.
Machines with electronic control are also suitable for
polishing.
For Your Safety
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions con-
tained therein are strictly followed.
In addition, the general safety notes
in the enclosed booklet must be ob-
served.
If the cable is damaged or cut through while work-
I
ing, do not touch the cable but immediately pull the
mains plug. Never use the machine with a dam-
aged cable.
Connect machines that are used outdoors by
I
means of a fault current protection switch (FI) with a
maximum triggering current of 30 mA. Use only an
extension cable that is approved for outdoor use.
Wear safety glasses.
I
Safety gloves are recommended.
I
Always direct the cable to the rear away from the
I
machine.
Secure the workpiece. A workpiece clamped
I
with clamping devices or in a vice is held more se-
cure than by hand.
The machine can be used only for dry sanding.
I
Working with material containing asbestos is not
I
permitted.
Always hold the machine firmly when working and
I
provide for a secure stance.
When sanding metal, flying sparks are produced.
I
Take care that no persons are endangered. Be-
cause of the danger of fire, no combustible materials
should be located in the vicinity (spark flying zone).
If your tool is equipped with a dust bag, empty it
I
frequently and after completion of sanding. Be
extremely careful of dust disposal, materials in fine
particle form may be explosive. Do not throw sand-
ing dust on an open fire. Spontaneous combustion
may in time, result from mixture of oil or water with
dust particles.
Always switch the machine off and wait until it has
I
come to a standstill before placing it down.
Never allow children to use the machine.
I
Bosch is able to ensure flawless functioning of the
I
machine only if the original accessories intended
for it are used.