Changing Basic Settings; Cleaning And Servicing; Cleaning Products - NEFF T18 D 6 Série Manuel D'utilisation

en Cleaning and servicing
Dis- Selection
play
Energy consumption display
Ask your electricity supplier what the mains
voltage is.
– Consumption display is switched off.
– Consumption display at mains voltage of
230 V.
– Consumption display at mains voltage of
400 V.
– Consumption display at mains voltage of
220 V.
– Consumption display at mains voltage of
240 V.
Automatic timer
– Switched off.
– Cooking time after which the hotplates
switch off.
Duration of the timer end signal
– 10 seconds.
– 30 seconds.
1
– 1 minute.
Activation of the heating elements
– Switched off
– Switched on
– The last setting before switching off the
hotplate.
Time for selecting hotplates
– Unlimited: The last hotplate selected can
always be adjusted without having to select it
1
again.
– You can adjust the last hotplate selected
within 10 seconds after selecting it. After this
time you have to select the hotplate again be-
fore adjusting it.
Resetting to the factory settings
– Switched off.
– Switched on.
1 Factory setting
14 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
14.1 Cleaning products
You can obtain suitable cleaning products and glass
scrapers from customer service, the online shop or a
retailer.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Never use unsuitable cleaning products.
▶
Unsuitable cleaning products
¡ Undiluted detergent
¡ Detergent intended for dishwashers
¡ Abrasive cleaners
¡ Aggressive cleaning products such as oven spray
or stain remover
36
1
1
1
13.2 Changing basic settings
Requirement: The hob is switched off.
Switch on the hob.
1.
Within the next 10 seconds press and hold
2.
approx. 4 seconds.
1
and
a
lights up on the right-hand display.
a
Repeatedly touch
3.
pears on the left-hand display.
Use or
4.
Press and hold
5.
a The setting is activated.
Tip: To exit the basic settings, switch off the hob using
. Switch the hob on again and reset.
¡ Abrasive sponges
¡ High-pressure or steam jet cleaners
14.2 Cleaning the glass ceramic
Clean the hob after every use to stop cooking residues
from getting burnt on.
Note: Note the information on unsuitable cleaning
products. → Page 36
Requirement: The hob has cooled down.
Remove heavy dirt using a glass scraper.
1.
Clean the hob with a cleaning product for glass
2.
ceramic.
Follow the cleaning instructions on the product
packaging.
Tip: You can achieve good cleaning results if you
use a special sponge for glass ceramic.
flash alternately on the left-hand display.
until the required indicator ap-
to set the required value.
for 4 seconds.
for