Troubleshooting; Information On Display Panel - NEFF T18 D 6 Série Manuel D'utilisation

14.3 Cleaning the hob surround
Clean the hob frame after use if dirty or stained.
Notes
¡ Note the information on unsuitable cleaning
products. → Page 36
15 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
15.1 Information on display panel
Fault
None
All displays flash
and the heat setting flash al-
ternately. A signal sounds.
and audible signal
Cause and troubleshooting
There has been a power cut.
Check the household fuse for the appliance.
1.
Check whether there has been a power failure by trying other electrical appli-
2.
ances.
The control panel is wet or objects are lying on it.
Dry the control panel or remove the object.
▶
Several hotplates have been used over a prolonged period at high power set-
tings. The hotplate has been switched off to protect the electronics.
Wait a while.
1.
Touch any touch field.
2.
a When the message no longer appears, the electronics have cooled down
sufficiently. You can continue to cook.
Despite being switched off by
hotplates have therefore been switched off.
Wait a while.
1.
Touch any touch field.
2.
a When the message no longer appears, the electronics have cooled down
sufficiently. You can continue to cook.
Hot pot near the control panel. There is a risk that the electronics will overheat.
Remove the pan.
▶
a The display goes out shortly afterwards.
Hot pot near the control panel. The hotplate has been switched off to protect the
electronics.
Remove the pot.
1.
Wait a while.
2.
Touch any touch field.
3.
a When the message no longer appears, the electronics have cooled down
sufficiently. You can continue to cook.
The hotplate was on for too long and has switched off automatically.
You can switch the hotplate back on again immediately.
¡ Do not use the glass scraper.
Clean the hob frame with hot soapy water and a soft
1.
cloth.
Wash new sponge cloths thoroughly before use.
Dry with a soft cloth.
2.
If the power cord of this appliance is damaged, it
▶
must be replaced by trained specialist staff.
WARNING ‒ Risk of burns!
The hotplate heats up but the display does not work.
Switch off the fuse in the fuse box.
▶
Call the customer service.
▶
WARNING ‒ Risk of fire!
The hob switches off automatically and can no longer
be operated. It may switch on unintentionally at a later
point.
Switch off the fuse in the fuse box.
▶
Call the customer service.
▶
, the electronics have become hot again. All
Troubleshooting en
37