Wipe Protection; Automatic Time Limit; Basic Settings; Changing The Basic Settings - NEFF T1 D20 Série Mode D'emploi

Wipe protection

If you wipe over the control panel while the hob is switched on,
settings may be altered.
To prevent this from happening, your hob has a wipe protection
function. Touch the " symbol. A signal sounds. The control

Automatic time limit

If a hotplate is in use for a long time without the setting being
changed, the automatic time limit is activated.
The hotplate stops heating. " and ‰ flash alternately in the
hotplate indicator.

Basic settings

Your appliance has various basic settings. You can adapt these
settings to your needs.
Indicator Function
Automatic childproof lock
™‚
‹ Switched off.*
‚ Switched on.
Audible signal
™ƒ
‹ Confirmation signal and operation error signal switched off.
‚ Only operation error signal switched on.
ƒ Confirmation signal and operation error signal switched on.*
Activation of the filament circuits
™ˆ
‹ Switched off.*
‚ Switched on.
ƒ Last setting before the hotplate was switched off.
Reset to basic setting
™‹
‹ Switched off.
‚ Switched on.
*Basic setting

Changing the basic settings

The hob must be switched off.
Switch on the hob.
1.
Within the next 10 seconds, touch the activation symbol ë or
2.
ð for 4 seconds.
™ and ‚ flash alternately in the left-hand display; ‹ lights up in
the right-hand display.
Touch the activation symbol, ë or ð, repeatedly until the
3.
desired indicator appears in the left-hand display.
22
panel is locked for 30 seconds. You can now wipe over the
control panel without altering any settings.
Note: The main switch is excluded from the wipe protection
function. You can switch off the hob at any time.
The display goes out when you touch any control. You can
make new settings.
When the time limit is activated depends on the heat setting
selected (1 to 10 hours).
Touch the + symbol repeatedly until the desired setting
4.
appears in the right-hand display.
Touch the activation symbol, ë or ð, for 4 seconds.
5.
The setting is activated.
Switching off
To exit the basic setting, switch off the hob with the main switch
and make new settings.