Operation - Aerial 5310-0016 Mode D'emploi

3. Slide the cover sheet (item 1) in the
dehumidifier in front of the notch
(item 2). To do this, loosen the
screw on the cover sheet and slide
the cover sheet to the top.
2
1
Next, expose the cover of the pump kit
connection (item 3) to enable the electri-
cal connection.
4. Undo the screw on the cover (item
3).
5. Rotate the cover upwards by 180°
and secure with the screw.
The dehumidifier is ready.
3
14
Connecting the pump kit
Procedure
1. Position the pump kit before open-
ing the dehumidifier.
2. Plug the connector on the connec-
tion cable into the pump kit port.
3. Depending on the model, either pull
together the sliding lock on the
pump kit or rotate the lock down
and carefully slide the pump kit into
the opening of the dehumidifier.
4. CAUTION! Risk of injury if pump
kit falls out!
Pump kit with sliding lock/
Secure the lock and check that it
fits properly.
5. Connect the proper hose to the dis-
charge nozzle and secure using a
pipe clamp.
The pump kit is connected. The dehu-
midifier can be put into operation. To do
so, read the operating instructions for the
dehumidifier.
8

Operation

The pump kit automatically starts pump-
ing out condensate water as soon as the
dehumidifier starts dehumidifying the
room. No further intervention is neces-
sary during operation.