Athena GET RX1 PRO Guide D'installation page 6

5.
Install GET Map Switch by
following the instructions in "Map
Switch Installation" Section in
GET RX1 Pro manual.
ATTENTION:
OEM handlebar commands for traction control and
map switch will not work after installing GET RX1
Pro ECU. Please only use GET Map Switch (included
in the kit) and GET LC-GPA module (sold separately).
The OEM mode button (blue one) can be used to
manage GET LC-GPA when installed.
6.
If included in the kit, install
GET WiFi-COM by following the
procedures in the dedicated manual.
7.
Re-install all the components
removed in the first step.
F. SYMBOLS AND CERTIFICATIONS
We declare that this product supplied is compliant with
RoHS Directive 2011/65/EU amended by the Directive
2015/863/EU (RoHS3) relative on the Restriction of
the Use of Certain Hazardous Substances.
EN
6