Athena GET RX1 PRO Guide D'installation page 5

REMEMBER TO WORK UNDER SAFETY CONDITIONS
AND TO KEEP THE ENGINE TURNED OFF.
1.
Remove the rear side panels,
the muffler, the voltage regulator,
and the ECU protective cover.
2.
Find the OEM ECU: check
on your motorbike's workshop
manual where to find it. Press
the retainer clip of the OEM ECU
connector before pulling it: make
sure to remove the connector
without damaging it.
3.
Insert the GET RX1 Pro ECU
into the rubber support and
connect it to the OEM connector.
Make sure the connectors are
properly plugged in, and the
retainer clip is fully engaged.
4.
Pass the 3 connector wires of
GET RX1 Pro ECU through the hole
of the OEM ECU protective cover.
Put the 3 RX1 Pro connectors
behind the voltage regulator so
that it can protect the connectors.
ATTENTION: DO NOT PINCH THE WIRES!
5
EN