Athena GET RX1 PRO Guide D'installation page 3

5. The RPM limiter threshold of the RX1PRO maps is higher
than the standard ECU.
6. To use and manage the GPA technology, it is necessary to install
GET GPA Switch or GET LC-GPA module (both sold separately), or
manage it with GET Maya Software (sold separately).
7. To change RX1 Pro injection map, it is necessary to use GET
Maya programming software (sold separately).
8. If the bike does not start or the engine is irregular, be sure
that the RX1 Pro ECU chosen is compatible with your bike
model and year, verify that the ECU is connected properly, and
always perform a TPS calibration.
9. For Honda CRF 450 2021-2022, the OEM traction control and
the OEM map switch button will not work when RX1 Pro ECU is
installed. Please only use GET Map Switch (included in the kit)
and GET LC-GPA module (sold separately). The OEM mode button
(blue one) can be used to manage GET LC-GPA when installed.
10. For Honda CRF 250 R 2022-2023, the OEM Mode button
(blue) can be used to manage GET LC-GPA when installed.
Please only use GET Map Switch (included in the kit) and GET
LC-GPA module (sold separately).
EN
3