KOBE IS2236SQF Manuel D'installation Et Mode D'emploi page 11

Hood Installation
11.
Place four (4 x 8 mm) temporary screws
(provided) to hold the duct cover up. Install
the hood as shown in Figure 5.
12.
Use eight (3/16x3/8 mm) screws (provided) to
secure hood to telescopic stack. Make sure
to tighten screws securely. Refer to Figure 5.
13.
Connect all the wire connections inside the
hood.
Install Accessories
14.
Place aluminum filters underneath the hood
Final Assembly
15.
Remove the temporary screws and slide the
outer duct cover downward so that it sits
properly on the hood.
16.
Turn power ON in control panel. Check all
lights and fan operation.
17.
Make sure to leave this manual for the
homeowner.
Figure 5
9