Description Of The Product - GYS Ergo Lift 650 Manuel D'utilisation Et De Maintenance

REGULAR SAFETY INSPECTION

Description of the product

Serial number
Verification phase
Presence of the technical panel on the hydraulic unit with
the serial number of the lift
Presence of the maximum load of 2000kg/4400lbs on the
lift with the serial number.
Up and down signalling by an arrow on the remote control
Presence of the operating instructions (original)
Tightening of nuts on all axes
Condition of hydraulic hoses and couplings
Status of the wired remote control and its power cord
The buttons on the wired remote control return to the
initial position automatically and charging stops.
The emergency stop button is functional.
Condition of the load‐bearing construction (mechanical
structure)
Functioning of the locking notches of the 4 supporting
elements and presence of the angular stops and locking
of the runners in their supports.
Condition of the cylinders (leaks, rust...)
Condition of the rubber pads
Condition of the power cord of the hydraulic power pack
General condition of the hydraulic unit
Double beep when the lift reaches its maximum
position.
Each time the descent button is pressed, a beep will
sound for 2 seconds before the table is lowered and an
audible signal will be emitted throughout the descent.
Functional test of the lifting platform with vehicle
(ideally with a weight close to 2T /
Control result
Security check carried out on: ................................................................................................
Name and address of the authorised person: ....................................................................................
4400lbs
)
Commissioning is not allowed
No anomalies: commissioning granted
ERGO LIFT 650
NOT
OK
OK
Signature of the authorised person
ERGO LIFT 650
Remarks
45