hestan GIMR15 Mode D'emploi page 5

IMPORTANT SAFETY INFORMATION
• Do not make any alterations to the ice machine. Alterations could result in electric shock, injury,
fire, or damage to the ice machine.
• The GREEN ground wire in the factory-installed power cord is connected to a screw on the
rear panel where the power cord enters the ice machine. If it becomes necessary to remove or
replace the power cord, be sure to connect the power cord's ground wire to this screw upon
reattachment.
ELECTRICAL SUPPLY ELECTRICAL SUPPLY
See rating label for electrical info. A dedicated 115 volt AC, 60 Hz, 15 Amp circuit breaker and
electrical supply is required. A Ground Fault Circuit Interrupter (GFCI) protected circuit must be
used when installed outdoors.
This appliance is NOT designed for installation in manufactured (mobile) homes or recreational park
trailers.
ADDITIONAL GENERAL INFORMATION ADDITIONAL GENERAL INFORMATION
All electrical instructions assume the outlet is located 4 - 10" [10 - 25 cm] above the floor surface.
Floor must be level in area of installation. Leg levelers are used for fine-tune adjustment only and
should not be used to compensate for floor differences exceeding 1/2" [13 mm].
This appliance is not intended for use by persons (including children) with reduced physical, sensory,
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
Children should be properly supervised around this appliance.
Do not climb, stand, or hang on the ice machine door or allow children or animals to do so. Serious
injury could occur or the ice machine could be damaged.
Be careful not to pinch fingers when opening and closing the door. Be careful when opening and
closing the door when children are in the area.
Do not use combustible spray or place volatile or flammable substances near the ice machine. They
might catch fire.
Keep the area around the ice machine clean. Dirt, dust, or insects in the ice machine could cause
harm to individuals or damage to the ice machine.
• Protect the floor when moving the ice machine to prevent damage to the floor.
• Follow the water supply, drain connection, and maintenance instructions carefully to reduce the
risk of costly water damage.
• In areas where water damage is a concern, install in a contained area with a floor drain.
• Install the ice machine in a location that stays above freezing. Normal operating ambient
temperature must be within 45 to 100°F [7 to 38°C].
• If using the optional drain pump (AGDP), test its operation every time the ice machine is cleaned
and sanitized. See page 19 "Optional Drain Pump AGDP" for details. If the optional drain pump
is not operating properly, water could back up and overflow, leading to costly water damage.
• To help ensure that the storage bin drain remains clear, follow the instructions on page 18
"Storage Bin Drain" once every 3 months or as often as necessary for conditions. If the storage
bin drain becomes clogged, water could build up in the bin and overflow, leading to costly water
damage.
• If water collects in the bin and will not drain, turn off the ice machine and close the water supply
line shut-off valve. Call for service.
• Do not leave the ice machine on during extended periods of non-use, extended absences, or in
sub-freezing temperatures. To properly prepare the ice machine for these occasions, follow the
instructions on page 20 "Preparing the Ice Machine for Periods of Non-Use."
(continued)
©2021 Hestan Commercial Corporation
EN
5