Preparing The Ice Machine For Periods Of Non-Use; Disposal - hestan GIMR15 Mode D'emploi

MAINTENANCE
8. Remove the discharge hose restriction and allow
the water to be pumped out normally. Power to
the ice machine will be restored when the water
EN
in the drain pump returns to a normal level.
9. If the ice machine fails to turn off with the
discharge hose restricted or the pump fails to
pump out the water, the appliance must be
serviced by a qualified service technician.

PREPARING THE ICE MACHINE FOR PERIODS OF NON-USE

During extended periods of non-use, extended absences, or in sub-freezing temperatures, follow the
instructions below. When the ice machine is not used for two or three days under normal conditions,
it is sufficient to move the control switch to the "OFF" position.
Only qualified service technicians should service this ice machine.
During extended periods of non-use, extended absences, or in sub-freezing temperatures, follow the
instructions below to reduce the risk of costly water damage.
1. Close the water supply line shut-off valve, then open the water supply line drain valve. See Fig.
30.
2. Allow the line to drain by gravity.
3. Attach a compressed air or carbon dioxide supply to the water supply line drain.
4. Move the control switch to the "ICE" position.
5. Blow the water supply line out using the compressed air or carbon dioxide supply.
6. Close the water supply line drain valve.
7. Move the control switch to the "OFF" position.
8. Unplug the ice machine.
9. Remove all ice from the storage bin. Clean the storage bin liner using a neutral cleaner. Rinse
thoroughly after cleaning.

DISPOSAL

This ice machine contains refrigerant and must be disposed of in accordance with applicable national,
state, and local codes and regulations. Refrigerant must be recovered by properly certified service
personnel.
20
©2021 Hestan Commercial Corporation
(continued)
Discharge Hose
Fig. 49