hestan GIMR15 Mode D'emploi page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE
CLEANING SOLUTION
CLEANING SOLUTION
Dilute 5 fl. oz. [148 ml or 10 tbs] of "Scale Away" with 1 gallon [3.8 l] of warm water. This is a
minimum amount. Make more solution if necessary.
IMPORTANT! For safety and maximum effectiveness, use the solution immediately after dilution.
CLEANING PROCEDURE
CLEANING PROCEDURE
1. Remove all ice from the evaporator and the storage bin.
Note: To remove cubes on the evaporator, move the control switch to the "OFF" position and
then move it back to the "ICE" position after 3 minutes. The harvest cycle starts and the cubes
will be removed from the evaporator.
2. Move the control switch to the "OFF" position.
3. Inside the storage bin, disconnect the suction tube by squeezing the tabs and pulling the tube
clear. See Fig. 34. Allow the water tank to drain.
4. Reconnect the suction tube as illustrated. See Fig. 35. Make sure the tabs lock into place; a loose
fitting may cause a water leak.
5. Slowly pour the cleaning solution into the water tank.
Tabs
Suction Tube
Fig. 34
6. Move the control switch to the "WASH" position.
7. Allow the cleaning solution to circulate for 30 minutes, then move the control switch to the
"OFF" position.
8. Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction tube.
9. Move the control switch to the "ICE" position and allow the ice machine to operate for
2 minutes. This allows the water tank to fill with water.
10. Move the control switch to the "WASH" position.
11. Allow the water to circulate for 5 minutes, then move the control switch to the "OFF" position.
12. Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction tube.
13. Repeat steps 9 through 12 three more times to rinse thoroughly.
SANITIZING SOLUTION
SANITIZING SOLUTION
Dilute 0.5 fl. oz. [14.8 ml or 1 tbs] of a 5.25% sodium hypochlorite solution (chlorine bleach) with 1
gallon [3.8 l] of warm water. This is a minimum amount. Make more solution if necessary. Using a
chlorine test strip or other method, confirm that you have a concentration of about 200 ppm.
IMPORTANT! For safety and maximum effectiveness, use the solution immediately after dilution.
(continued)
Water Tank
Drain
Tabs
Suction Tube
Fig. 35
©2021 Hestan Commercial Corporation
EN
15

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Giml15

Table des Matières