hestan GIMR15 Mode D'emploi page 18

MAINTENANCE
18. Discard the sanitizing solution.
19. Mix a new batch of the sanitizing solution and slowly pour it into the water tank.
EN 20. Move the control switch to the "WASH" position.
21. After circulating the sanitizing solution for 15 minutes, move the control switch to the "OFF"
position.
22. Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction tube.
23. Repeat steps 19 through 22 one time.
24. Move the control switch to the "ICE" position and allow the ice machine to operate for
2 minutes. This allows the water tank to fill with water.
25. Move the control switch to the "WASH" position.
26. Allow the water to circulate for 5 minutes, then move the control switch to the "OFF" position.
27. Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction tube.
28. Repeat steps 24 through 27 two more times to rinse thoroughly.
29. Clean the storage bin liner, door liner, and door gasket with a neutral cleaner. Rinse thoroughly
after cleaning.
30. Move the control switch to the "ICE" position to start the automatic icemaking process.
STORAGE BIN DRAIN STORAGE BIN DRAIN
In some conditions, slime may build up inside the storage bin drain and prevent water from draining
properly. To prevent this buildup, perform the following procedure once every 3 months or as often
as necessary for conditions.
If the storage bin drain becomes clogged, water could build up in the bin and overflow, leading to
costly water damage.
1. Move the control switch to the "OFF" position.
WARNING! To reduce the risk of electric shock, do not touch the control switch with damp
hands.
2. Remove all ice from the storage bin.
3. Mix a batch of sanitizing solution by diluting 1.25 fl. oz. [37 ml or 2.5 tbs] of a 5.25% sodium
hypochlorite solution (chlorine bleach) with 2.5 gallons [9.5 l] of warm water. Using a chlorine
test strip or other method, confirm that you have a concentration of about 200 ppm.
4. Slowly pour the sanitizing solution into the storage bin.
5. After all of the solution has drained, clean the storage bin liner with a neutral cleaner. Rinse
thoroughly with clean water.
6. Move the control switch to the "ICE" position to start the automatic icemaking process.
18
©2021 Hestan Commercial Corporation
(continued)