hestan GIMR15 Mode D'emploi page 19

MAINTENANCE
CONDENSER CONDENSER
Check the condenser once a year, and clean if required by following the steps below. More frequent
cleaning may be required depending on location.
• Move the control switch to the "OFF" position and unplug the ice machine from the electrical
outlet before cleaning the condenser.
WARNING! To reduce the risk of electric shock, do not touch the control switch with damp
hands.
• Condenser fins are sharp. Use care when cleaning.
1. Move the control switch to the "OFF" position and unplug
the ice machine from the electrical outlet.
2. Remove the 2 screws securing the front panel, then remove
the panel. See Fig. 48.
3. Remove the 2 screws securing the louver, then remove the
louver.
4. Use a brush attachment on a vacuum cleaner to gently clean
the condenser fins. Do not use too much force, otherwise
the fins could be damaged.
5. Replace the louver and front panel in their correct positions.
Ensure that the screws are securely in place.
6. Plug the ice machine back in. Move the control switch to
the "ICE" position to start the automatic icemaking process.
OPTIONAL DRAIN PUMP (AGDP) OPTIONAL DRAIN PUMP (AGDP)
If the optional drain pump (AGDP) is installed, test its operation at least once a year as outlined
below. Note that the pump has power even when the control switch is in the "OFF" position.
If the optional drain pump is not operating properly, it will adversely affect performance, component
life, and warranty coverage and may result in costly water damage.
1. Move the control switch to the "OFF" position, then unplug the ice machine from the electrical
outlet.
WARNING! To reduce the risk of electric shock, do not touch the control switch with damp
hands.
2. Remove all ice from the storage bin.
3. Plug the ice machine back in.
4. Slowly pour 24 to 30 oz. [710 to 890 ml] of water over the storage bin drain hole in the storage
bin.
5. If water pumps out properly and the drain pump then de-energizes, proceed to step 6. If water
does not pump out properly and/or the drain pump does not de-energize, the appliance must be
serviced by a qualified service technician before proceeding.
6. Move the control switch to the "ICE" position.
7. Pour another 24 to 30 oz. [710 to 890 ml] of water into the ice machine's ice storage bin, then
completely restrict the discharge hose while the drain pump is operating. See Fig. 49. Pour more
water into the ice machine's ice storage bin until the ice machine turns off. The drain pump will
continue to operate. Check for leaks.
(continued)
Front Panel
Condenser
Screws
Screws
Louver
Fig. 48
©2021 Hestan Commercial Corporation
EN
19