Denon DJ Prime GO Guide D'utilisation Rapide page 5

8. Shift: Press and hold this button to access secondary functions
of other controls.
9. Master Level Meters: These LEDs display the audio signal level
of the master mix (sent out of the Master Outputs).
10. Sweep FX: Turn this knob to control the active Sweep FX 1 or
FX 2. Available selections are Filter and Wash Out.
•
Filter: This effect applies a filter to the channel. Starting
from the center (12:00) position, turn a Sweep FX knob
counter-clockwise to apply a low-pass filter, or turn it
clockwise to apply a high-pass filter.
•
Wash Out: This creates a transition effect. Turn a Sweep
FX knob to its most counter-clockwise (minimum) position
to apply a 1-beat echo that will also mute the channel's
normal audio signal, or turn it to its most clockwise
(maximum) position to apply a 1/2-beat echo.
11. Sweep FX 1: Press this button to activate Sweep FX 1 and use
the Sweep FX knob to control the parameters for FX 1. Use the
touchscreen to select and assign the effect for FX 1. By default,
Filter is assigned to FX 1.
12. Sweep FX 2: Press this button to activate Sweep FX 2 and use
the Sweep FX knob to control the parameters of Sweep FX 2.
Use the touchscreen to select and assign the effect for FX 2. By
default, Wash Out is assigned to FX 2.
13. Channel Cue: Press this button to send the channel's pre-fader
signal to the headphones' cue channel.
14. Channel Fader: Use this fader to adjust the channel's volume
level.
15. Crossfader: Use the crossfader to mix between Deck 1 and
Deck 2.
16. Hot Cue: Press this button to enter Hot Cue mode.
17. Loop: Press this button once to enter Saved Loop mode.
18. Roll: Press this button to enter Roll mode.
19. Bank: This button is used to change the value of the 4 performance pads. The button will blink
while accessing pads 5-8.
20. Performance Pads: These pads have different functions on each deck depending on the
current pad mode. See the full User Guide for more information.
21. Auto Loop: Turn this knob to set the size of an automatic loop. The value will be shown in the
touchscreen.
Press this knob to activate or deactivate an automatic loop at the current location of the track.
Jump/Move: Press and hold Shift and turn this knob to shift the active loop to the left or right
(Loop Move). When the loop is inactive, press and hold Shift and turn this knob to jump
forward or backwards in the track by a pre-determined quantized value (Beat Jump).
10
11
12
13
8
14
16 17 18 19
20
9
15
21
5