Maintenance And Care; Troubleshooting - Kärcher Puzzi 8/1 C Mode D'emploi

Empty the fresh water reservoir and
switch the appliance off.
Remove the lid.
Figure 8, see cover page
Remove the dirt water reservoir
from the appliance and empty it.
Cleaning the device
Connect the bender (with suction
pipe and nozzle) to the suction
hose.
Connect the coupling of the fresh
water hose to the bender and lock
into place.
Figure 9, see cover page
Fill approx. 2 litres of fresh water
into the fresh water reservoir.
Do not add any detergents.
Figure 10, see cover page
Place nozzle into the dirt water res-
ervoir.
Press the spray switch to turn on
the detergent pump.
Activate lever on bender and flush
the appliance for appr. 1 to 2 min-
utes.
Turn off the appliance.
Disconnect the mains plug from the
socket.
Figure 11, see cover page
Remove the dirt water reservoir
from the appliance and empty it.
Clean the external surfaces of the
appliance.
Coil power cable around the carry-
ing handle and the lid (see overview
on title page).
Figure 12, see cover page
For transport, place suction pipe on
the carrying handle and attach
spray/suction hose to hook.

Maintenance and care

Danger
Danger of injury by electric shock.
First pull out the plug from the mains
before carrying out any tasks on the
machine.
Check high power cable, extension ca-
bles and hoses for damage every time
before use.
Remove all water from the appliance
prior to longer periods of non-use to
avoid offensive odours.
Clean the sieve in the fresh water reser-
voir and the lint trap next to the dirt wa-
ter reservoir regularly.

Troubleshooting

Danger
Danger of injury by electric shock.
First pull out the plug from the mains
before carrying out any tasks on the
machine.
Get the electrical components checked
and repaired only by authorised cus-
tomer service persons.
Contact an authorised customer ser-
vice person in case of problems not
mentioned in this chapter or if you are
in doubt or when you have been explic-
itly asked to do so.
No water exiting from nozzle
Fill up fresh water reservoir.
Check couplings on the fresh water
hose for proper connection.
Loosen nozzle attachment and re-
move, clean or replace nozzle.
Clean the sieve in the fresh water
reservoir.
Detergent pump defective, contact
Customer Service.
9
English