Care And Maintenance - Kärcher OC 3 Mobile Outdoor Cleaner Mode D'emploi

Operation with detergent
DANGER
When using detergents, the material data safety sheet
issued by the detergent manufacturer must be adhered
to, especially the instructions regarding personal pro-
tective equipment.
Do not fill or suction detergent or other additives into the
tank.
 Spray the detergent sparingly on the dry surface
and allow it to react, but not to dry.
 Rinse off loose dirt.
Operation with universal brush
ATTENTION
Risk of damage to the paintwork
When working with the universal brush, it must be free
of dirt or other particles.
Illustration
 Install the universal brush.
Interrupting operation
 Release the lever on the trigger gun.
After another 5 minutes without being pressed, the de-
vice shuts off automatically.
Finish operation
To avoid damage:
 Remove the tank or suction hose.
 Turn on the appliance.
 Push the lever of the trigger gun until no more wa-
ter is emitted.
 Release the lever on the trigger gun.
 Completely empty the tank.
 If necessary, reinsert the valve and fine filter.
ATTENTION
Appliances and accessories that are not completely
drained can be destroyed by frost. Completely drain ap-
pliance and accessories and protect them against frost.
Transport
CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during transport.
When transporting by hand
 Lift appliance by the carrying handle and carry it.
When transporting in vehicles
 Secure the appliance against shifting and tipping
over.
Storage
CAUTION
Risk of personal injury or damage!
Consider the weight of the appliance when storing it.
Storing the Appliance
 Park the machine on an even surface.
 Do not store the device at temperatures above
40°C and under 0°C.

Care and maintenance

DANGER
Risk of electric shock.
 Turn the device off and disconnect from the charg-
er before carrying out any tasks on the device.
Clean valve/fine filter
Clean valve and fine filter regularly.
ATTENTION
Valve and filter must not be damaged.
Illustrations
 Remove the valve and fine filter using the suction
hose connection or a suitable pair of pliers.
 Clean the valve and fine filter under running water.
 Reinsert the valve and fine filter.
Troubleshooting
DANGER
Turn the device off and disconnect from the charger be-
fore carrying out any tasks on the device.
Repair work and work on the electrical components may
only be performed by an authorised customer service.
You can rectify minor faults yourself with the help of the
following overview.
If in doubt, please consult the authorized customer ser-
vice.
Appliance is not running
 Check the battery's charging state and charge it if
necessary.
Motor overloaded, the motor circuit breaker has tripped.
 Turn off the appliance.
 Switch on the device and put it into operation again.
At ambient temperatures below 0°C or above 40°C, the
motor circuit breaker will be tripped.
 Turn off the appliance.
 Allow device to cool down/heat up.
 Switch on the device and put it into operation again.
If the malfunction occurs repeatedly, have the device
checked by the customer service.
Pressure does not build up in the appliance
 Make sure there is enough water in the tank or wa-
ter container.
 Clean valve and fine filter.
Strong pressure fluctuations
 Clean the nozzle: Remove contamination and de-
bris from the nozzle drill, using a needle and rinse
through with water towards the front.
 Make sure there is enough water in the tank or wa-
ter container.
Appliance is leaking
 Dropwise leakage of the device is normal for tech-
nical reasons. If the leakage increases contact the
authorized customer service.
– 5
EN
-
15