Electrolux ERF3867SOW Notice D'utilisation page 38

Masquer les pouces Voir aussi pour ERF3867SOW:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

38
www.electrolux.com
8.2 Location
To ensure best performance, if the
appliance is positioned below an
overhanging wall unit, the minimum
distance between the top of the cabinet
and the wall unit must be at least 40 mm.
Ideally, however, the appliance should not
be positioned below overhanging wall
units.
The ventilation space can be:
• directly above the appliance
• behind and above the top cupboard.
In this case, the space behind the top
cupboard must be at least 50 mm
deep.
8.3 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
8.4 Rear spacers
Install the two spacers and the locking
pins provided within the accessory bag as
shown in the figure.
50 mm
8.5 Levelling
When placing the appliance ensure that it
stands level. If necessary adjust the feet
using the adjustment spanner supplied.
Door alignment is dependent on proper
levelling.
8.6 Removing the transport
support
Your appliance is equipped with transport
support to secure the door during
transportation.
1. Open the door.
2. Remove the transport support (2) from
3. Remove the transport support (3) from
the door sides.
the lower hinge (some models).

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Erf3867sox

Table des Matières