Electrical Connection - Gram Gastro 07 Mode D'emploi

Electrical connection

Read the text below thoroughly before electrical connection.
The cabinet is intended for connection to alternating current. The connection
voltage (V) and frequency (Hz) are shown on the name plate in the cabinet (see Fig.
9). Only the supplied cord is to be used.
Never use an extension cord for this appliance!
If a wall socket is placed in a longer distance than the length of the supplied power
cord, contact an electrician to establish a wall socket within the range of the
supplied power cord.
If the counter is defective, it must be examined by a service electrician from Gram
Commercial or an authorised refrigeration company with knowledge of Gram's
products.
Always disconnect the power if interruptions in power supply occur, and when electrical
parts are removed/put on, and before cleaning and maintenance of the appliance.
Repairing of electrical/technical parts may only be performed by a service electrician from
Gram Commercial or an authorised refrigeration company with knowledge of Gram's
products.
Do not use the appliance before all coverings are installed, so that live or rotating machine
parts can not be touched.
The counter is not to be used outdoor.
All earthing requirements stipulated by the local electricity authorities must be observed.
The cabinet plug and wall socket should then give correct earthing. If necessary, contact an
electrician.
Make sure the appliance is switched off at the socket before service is performed
on electrical parts. It is not sufficient to switch off the cabinet by the START/STOP
key as there will still be voltage to some electrical parts of the counter.
765041480 Rev. 000 33