Ferm CRM1054 Traduction De La Notice Originale page 9

Continuous operation
Sound pressure level LPA
Sound power level LWA
* For optimal lifetime performance, do not operate
device uninterrupted for more than 10 minutes;
then wait for 10 minutes.
Only use the following batteries of the FERM
POWER 20V battery platform. Using any other
batteries could cause serious injury or damage
the tool.
CDA1136 20V, 2Ah Lithium-Ion
CDA1138 20V, 4Ah Lithium-Ion
The following charger of the can be used to
charge these batteries.
CDA1137 Quick charger
The batteries of the FERM POWER 20V battery
platform are interchangeable with all the FERM
POWER 20V battery platform tools.
Description
The numbers in the text refer to the diagrams on
page 2-4.
Fig. A-H
1. Machine
2. Battery (not included)
3. Battery unlock button
4. Worklight
5. Charger (not included)
6. Charging LED indicator
7. Clamping lever
8. High pressure connection valve
9. High pressure hose
10. Storage channel high pressure hose
11. Low pressure hose
12. Storage low pressure hose
13. Large / medium/small connector for inflating/
deflating
14. Extra small valve adapter
15. Valve adapter for balls
16. Valve adapter for Dunlop/blitz bicyle valves
17. Valve adapter for Presta bicyle valves
18. Valve adapter for Schrader bicycle valves
19. Valve adapter storage
20. Mode selector I / O / II
21. Controle panel + / "PSI/BAR/KPA" / -
22. Inflator connection machine
23. Nubs
max. 10 min*
24. Notches
71.2 dB(A), K=3dB(A)
25. Deflate connection machine
82.2 dB(A), K=3dB(A)
26. Switch worklight
27. Battery indication button
28. Display
3. OPERATION
First use
Fig. A
Place the product on a even, nonflammable
surface. Depending on the inflatable or the tyre
you can use high or low pressure. High pressure
setting is best to be used when pre-set is needed;
preset the desired pressure and the machine will
automatically stop at the set pressure.
Low pressure setting is best to be used for
inflating and deflating larger inflatables.
• Depending on the tyres you can use the high
pressure connection valve (8) directly or along
with one of the included valve adapters (16,
17, 18)
• For balls (high pressure) use valve adapater for
balls (15)
• For high pressure inflatables with a small valve
use the extra small valve adapter (14)
• Depending on the inflatable you can use the
Low pressure connection (11) directly or along
with one of the included hose adapters (13)
This product is not suitable for continuous
operation. It was developed to produce air pressure,
not air volume. Do not use the product for longer
than 10 minutes without interruption to prevent
overheating and damage to the device. Afterwards
allow to cool for a minimum of 10 minutes.
Do not operate the device in dusty
environments. Doing so poses a fire
hazard and could damage the device.
To prevent overheating while inflating,
keep the air intake and vents clear of
obstructions. Always wear EN-approved
eye protection during use.
For inflatables with counterpressure (e.g.
partly filled car tyre): Switch on the
product before connecting the High
pressure connection valve (8) to the tyre.
9