Sharp PA-VR10E PC Mode D'emploi page 26

Press the
7
setting for the start time and then press the OK button.
Next, the "minutes" setting flashes. Use the same procedure to
select the minutes setting and then press the OK button.
Press the
8
"DAILY" and then press the OK button.
(The "ONCE" setting plays the alarm
message one time only. The "DAILY" setting
plays the alarm message every day.)
Tip
• To use a message recorded earlier, use the
button after step 4 to select "RECALL" and then press the OK
button. Then set the alarm time.
• Messages are recorded with the microphone sensitivity set to
"LOW" and "HQ" selected as the recording mode. These settings
cannot be changed.
• If the set time is reached while you are playing a recording,
playback stops and the recorder plays the message alarm.
• If the set time is reached while you are making a recording, the
message alarm icon flashes on the display but recording is not
interrupted.
• If the set time is reached while the digital voice recorder is
connected to a personal computer, the message alarm icon
flashes on the display. The recorder plays the message alarm as
soon as it is disconnected from the personal computer.
Using an alarm tone
To have the recorder sound an alarm tone, select "CHIME" in step 4
and then set the alarm time.
Timer function
The recorder's timer function sounds an alarm once a set time has
elapsed. You can set the timer delay to be from 1 to 99 minutes.
Press the STOP/MENU button once or twice to display the
1
menu screen.
Press the
2
(timer function) screen appears on the display, then press
the OK button.
The timer delay settings screen appears.
E-24
L M
(+) or (-) cursor button to select the "hour"
L M
(+) or (-) cursor button to select "ONCE" or
L M
(+) or (-) cursor button until the "TIMER"
DA I LY
L M
(+) or (-) cursor