Télécharger Imprimer la page

aidapt Coniston VR130 Notice D'installation Et D'entretien page 6

Publicité

Les langues disponibles

Les langues disponibles

REISSUE
If you reissue or are about to reissue this product, please thoroughly check all components
for their safety.
This includes:
Tightness of all nuts/bolts/castors and other screw in/bolt in/push in components.
Also check all upholstery (if applicable) for security, splits, exposed staples, etc.
If in any doubt, please do not issue or use, but immediately contact your supplier for
service support.
When reissuing, a risk assessment may be required as to the suitability of the chair for a
particular user
USE OF BATH OILS
Caution should be observed if you are using any form of bath oils or oily skin preparation
with your Coniston as this may impair your natural contact skin resistance.
In the event of using any such oil, your seat must be thoroughly cleaned with a suitable
detergent to break down any oily residue. Failure to observe this recommendation could
impair your safety.
CARE & MAINTENANCE
Your Coniston rotating bather is provided with the spline and female coupling pre ‑ g reased.
It will be necessary for you to re-grease on an occasional basis; this will ensure the continued
smooth operation of your product.
The first sign of the need to re-grease will be when the rotating action becomes tight, this is
normally followed by a squeaking noise.
To carry out the re-grease simply remove the seat section from the base exposing the spline
and female coupling. Grease both sections and carefully reassemble following the
instructions under sections 5.8 and 6 above.
IMPORTANT INFORMATION
The information given in this instruction booklet must not be taken as forming part of or
establishing any contractual or other commitment by Aidapt Bathrooms Limited, Aidapt
(Wales) Ltd or its agents or its subsidiaries and no warranty or representation concerning the
information is given.
Please exercise common sense and do not take any unnecessary risks when using this
product; as the user you must accept liability for safety when using the product.
Please do not hesitate to contact the person who issued this product to you or the
manufacturer (detailed below) if you have any queries concerning the assembly/use of your
product.
Aidapt Bathrooms Ltd, Lancots Lane, Sutton Oak, St Helens, WA9 3EX
Telephone: +44 (0) 1744 745 020 • Fax: +44 (0) 1744 745 001 • Web: www.aidapt.co.uk
Email: accounts@aidapt.co.uk • adaptations@aidapt.co.uk • sales@aidapt.co.uk
Fixing and Maintenance Instructions
6
Ver.4 08/2012 (1562)

Publicité

loading