Publicité
Les langues disponibles
Les langues disponibles
INTRODUCTION
Thank you for choosing to purchase the Coniston Rotating Bather. The Coniston is
manufactured using only the finest materials available. If used in accordance with the user
instructions the Coniston should give you many years of continuous service.
DUTY OF CARE
Always consult with the prescriber/Physiotherapist if you are in any doubt that this
product is suitable for your use.
N.B. This equipment must be installed by a competent person and a risk assessment
may be needed as to the suitability of the chair for the particular user.
150 kg (24st.) weight limit.
Do not exceed the weight limit stated – doing so could put the user at risk.
BEFORE USE
Carefully remove all packaging. Avoid using any knives of other sharp instruments
•
as this may damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault,
•
do not use your product, but contact your supplier for support.
INTENDED USE
The Coniston is designed to traverse a rectangular bath of the following widths; 700 mm,
750 mm and 800 mm (nominal) only. The seat rotates enabling the user to transfer onto the
seat, then rotate back and lock into position facing down the bath. It is designed to be used
as a bathing aid only.
CONSTRUCTION
Frame
Side bath grippers
Side bath adjusters
Seat
Fixing and Maintenance Instructions
Non-rust Aluminium
Stainless steel and plastic
Stainless steel, alloy and plastic/rubber
Polypropylene plastic in two sections:
Top section consisting of seat arms and lock handles
Bottom section consisting of bath frame with adjusters
2
Ver.4 08/2012 (1562)
Publicité
