Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
1.
Firstly remove the Coniston rotating bather from its packaging. Visually check for
any damage and fully test all moving parts prior to installation.
2.
Check the width of the bath you intend to install the Coniston rotating bather onto.
The Coniston is designed to fit onto three nominal widths of bath, these are 700
mm, 750 mm and 800 mm. These widths are the most common found in the EU.
Do not attempt to install the Coniston on any other type of bath, doing so
may seriously compromise the safety of the user.
3.
Once you have checked the width of the bath, if necessary, adjust all four of the
width adjusters. If the Coniston is to be installed on a 700 mm wide bath, leave the
width adjuster in the closed position.
If the bath is wider than 700 mm, it may be necessary to alter the width adjuster
(see fig. 1). This is achieved by carefully removing the 'E' clip (see fig. 1a) and
pulling the blue plastic coloured bath gripper towards you.
fig.1
4.
When you are satisfied that you have located the correct punched hole (this is
normally the second punched hole for 750 mm wide baths and the third punched
hole for 800 mm wide baths).
Under no circumstances must any further holes be drilled or punched into
the Coniston to further increase the width as this could seriously
compromise the user's safety and will invalidate any warranty.
5.
Once you are satisfied that you have located the correct pre-punched hole carefully
reinsert the 'E' Clip (see fig. 1a) ensuring that it passes completely through the
frame (see fig. 2).
Fixing and Maintenance Instructions
fig. 1a
3
fig. 2
Ver.4 08/2012 (1562)
Publicité
