Part3 For The Manager Prior To Programming; Procedure For Programming; Guidance Messages - Sharp XE-A203 Manuel D'instructions

Part3 FOR THE MANAGER
PRIOR TO PROGRAMMING

Procedure for programming

1.
Check to see whether a paper roll is present in the machine. If there is not enough
paper on a roll, replace it with a new one (refer to "Replacing the Paper Roll" on
page 82 for the replacement).
2.
Put the manager key in the mode switch and turn it to the PGM position.
3.
Program necessary items into the cash register.
Every time you program an item, the cash register will print the setting. Please refer to print samples in each
section.
4.
If necessary, issue programming reports for your reference.
• On the key operation example shown in the programming details, numbers such as "22052007"
indicates the parameter which must be entered using the corresponding numeric keys.
• Asterisks in the tables shown in the programming details indicate default settings.

Guidance messages

Depending on programming items, the register shows guidance messages on the operator display to indicate a
programming item you are in, or guidance to enter data, as shown in the examples below.
Your register allows you to program all necessary data in one procedure with the guidance messages for
department programming (page 16), PLU (Price Look-Up) and subdepartment programming (page 21),
-
programming for the
messages, please refer to each section.
Example 1: For key entry type programming
Key operation example
Parameter/price entry
Press of the subjected key
¥ Guidance message is displayed.
To terminate
% & V r R
, , , , ,
008
(In case of parameter entry)
s
A
X Y c b
, , , and keys (pages 46-54). For their guidance
@
PAYMENT KEY PROG
REG
OPX/Z
PGM
Operator display
008
To repeat
(depending on programming)
Guidance message is kept
displaying until you press
A
the key.
0.00
MGR
X1/Z1
X2/Z2
43