emerio FN-120956 Mode D'emploi page 5

FN-120956 EN
PARTS DESCRIPTION
1. Fan guard
2. Fan blade
3. U-holder
4. Speed switch
5. Locking knob
6. Height adjustment pipe
7. Fastening knob
8. Tripod holder
9. Tripod leg
10. Butterfly fastening screw and nut
11. Metal link pipe
ASSEMBLING INSTRUCTIONS
1. Tripod leg assembly
1) Take out the securing screws and nuts.
2) Attach the metal part of the wooden tripod leg to the tripod holder, line up the holes and fit the securing
screws all the way through. Take note of the orientation of the leg end.
3) Fit the nut to the protruding end of the screw and tighten the nut.
4) Repeat for the other two legs.
5) Open out the legs, connect the three metal link pipes by the butterfly fastening screw and nut.
6) Adjust the height adjustment pipe to your desired height and tighten the fastening knob.
- 4 -