Check-Out And Operation; Turning The Welding Unit On; Entering The Welder Id Code - TEGA 4000-S Manuel Utilisateur

8
Welding data transfer is enabled through an interface of the USB A type,
which is compatible with a USB stick.
Further Optional Accessories
• PC software for downloading and archiving data on PC (for all common
Windows operating systems)
• USB stick for data transfer from the welding unit on the worksite to the
printer or PC in your office (see details at the end of this booklet)
5

Check-out and Operation

• To operate the welding unit, be sure that it is set on a proper, level
surface.
• Be sure that power supply/generator protection is 16 A (slow blow).
• Plug the power supply cord into the mains power supply or the genera-
tor.
• Read and comply with the User's Manual of the generator, if appli-
cable.
5.1

Turning the Welding Unit on

After connecting the power supply cable to mains power or a generator,
turn the welding unit on using the On/Off switch. This causes Display 1 to
show.
Then the screen changes to Display 2.
CAUTION in case of System Errors!
If during the auto-test that the unit performs at start-up, an error
is detected, a "System Error" message shows on the display.
When this happens, the welding unit has to be disconnected im-
Caution
mediately from the power suppy and the fitting, and it has to be
shipped to the manufacturer for repair.
5.2

Entering the Welder ID Code

The alphanumeric keypad is designed and works like the keypad
of a common mobile phone without touch screen display. All
characters found on a key can be "browsed" by pressing that key
repeatedly at short intervals. As soon as "browsing" generates
Info
the desired character on the screen, wait a little longer until
you press the next key to use the displayed character. The first
character always is the number on the respective key, then the
letters or marks in the order on the key, i. e., for instance, with
the key "2 | a | b | c" the 1
the 3 "b," and the 4
rd
ters appear on the screen. To enter upper-case letters, hold down
the ñ key while selecting the appropriate letter by one or several
keypresses.
The welding unit can be configured to ask for the welder identification
code before the fitting code is entered. The display screen then shows
the message "Enter Welder Code." (Later this screen can be accessed by
a quick access routine; see Sect. 6.1.) The numeric code can be entered
either by reading it from a tag with the scanner or by using the alphanu-
meric keypad.
When the welder code is read from a bar code using the scanner, an audible
signal confirms this and the screen shows the read code and switches to
the next input display. When the code is entered manually, it is saved by
All manuals and user guides at all-guides.com
English
keypress brings up "2," the 2
st
brings up "c." By default, lower-case let-
th
4000-S
Version December 2013
********************
Tega
********************
Enter Barcode
14:32:22
Supply V.: 230V 50Hz
No Contact
"a,"
nd
** Welder ID Code **
++++++++++++++++++++
++++++++++
T E G A M u h e n d i s l i k S a n a y i v e T i c a r e t A . Ş .
06930 Sincan Ankara, Turkey
TEGA
4000-S
Display 1
21.10.12
Display 2
Display 3