Using The Machine; Using For The 1 St Time; Starting Up; Cleaning - EMGA 408.100 Mode D'emploi

USING THE MACHINE

USING FOR THE 1
1. Unclip the locking loop (3)
2. Open the guide channel (2)
3. Remove the ejector (12) from the motor spindle (18) and wash it in fresh water.
4. Wash all the items in contact with food in fresh water: the guide channel (2), the dirt
tray (9), the large diameter ram (5), the reducer (6), the small diameter ram (7), the
slicer disk (14) and the grater disk (13).
!
TAKE CARE: RISK OF CUTS ON HANDLING THE KNIVES.

STARTING UP:

1. After selecting the appropriate tool for the work required (grating or slicing), fit the
ejector (12) smooth side on the disk side and the disk (13) onto the motor spindle
(18).
2. Close the guide channel (2).
3. Place a recipient under the appliance outlet
4. Lock the guide channel (2) with the locking loop (3) and position on the clip (4).
5. Plug the power supply plug (10) into your mains power socket.
6. Switch the machine on by putting the On/Off switch (11) to the 1 position; the
indicator lights up.
7. Introduce the products into the guide channel (2) or into the reducer (6).
8. Push the products in using the large diameter ram (5) or the reducer (6) and the
small diameter ram (7) until the ram reaches the collar.

CLEANING:

IMPORTANT:
 Stop the machine and unplug the machine power supply lead.
!
 The appliance must not be cleaned either with a water spray
or pressure jet, nor should it be immersed
For easier cleaning, do not allow food to dry on the guide channel (2), the grater disk (13),
the slicer disk (14), the ejector (12) or the dirt tray (9). It is recommended that all these
machine parts are cleaned as soon as the work is finished.
98148 US 3.2 - 12 2010
408100-200 en ma 2010.12
ST
TIME:
7 / 14 www.santos.fr
7/14