Technical Data - JUNO JKSN301R1 Notice D'utilisation

32
Problem
and a number come
on.
You can hear a constant
beep noise.
comes on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an

TECHNICAL DATA

Cooking zones specification
Cooking zone
Middle front
Middle rear
For optimal cooking results use cookware
no larger than the diameter of the cooking
zone.
Possible cause
There is an error in the hob.
The electrical connection is
incorrect.
The second phase of the
power supply is missing.
Nominal Power (Max heat set‐
ting) [W]
1200
700 / 1700
Remedy
Deactivate the hob and acti‐
vate it again after 30 seconds.
If
nect the hob from the electrical
supply. After 30 seconds, con‐
nect the hob again. If the prob‐
lem continues, speak to an
Authorised Service Centre.
Disconnect the hob from the
electrical supply. Ask a quali‐
fied electrician to check the in‐
stallation.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse, wait
one minute, and insert the
fuse again.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
Cooking zone diameter [mm]
145
120 / 180
comes on again, discon‐