Safety Information; Preparation; Hardware Contents; Disassemble Light Fixture - Heath Zenith DualBrite 4558 Instructions D'installation Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SAFETY INFORMATION

Please read and understand this entire manual before at-
tempting to assemble, operate, or install the product.
This light fixture requires 120-volts AC. All wiring must be
in accordance with the National Electrical Code (Canadian
Electrical Code in Canada). Some local electrical codes
require installation by a qualified electrician.
WARNING
• Turn power off at circuit breaker or fuse when
wiring fixture. Place tape over circuit breaker
switch and verify power is off at the fixture.
CAUTION
• Do not cut any wires that have factory installed
wire connectors or remove the wire connectors.

PREPARATION

Before beginning installation of product, make sure all parts
are present. Compare parts with hardware contents list. If
any part is missing or damaged, do not attempt to assemble,
install, or operate the product.
Tools Required for Assembly (not included): Phillips and
flathead screwdrivers, pliers, wire strippers/cutters, multi-
meter, electrical tape, silicone sealant, safety glasses, work
gloves, and ladder
• For easy installation and to operate the light using Manual
mode, replace an existing light fixture operated by a wall
switch.
• Do not connect to dimmers or timers.
• For best performance, mount fixture about 8 feet (2.4 m)
above the ground.
Estimated Installation Time: 30 minutes

HARDWARE CONTENTS

Note: Illustrations may vary from actual unit.
2x – Wire Connectors
2x – Mounting Screw
2x – Decorative Nut
(Pre-installed)

DISASSEMBLE LIGHT FIXTURE

1. Remove two decorative nuts from light fixture cover.
2. Remove cover from base.

LIGHT FIXTURE INSTALLATION

WARNING: Turn power off at circuit breaker
or fuse. Place tape over circuit breaker switch and
verify power is off at the fixture.
For best performance, mount the fixture about 8 feet (2.4 m)
above the ground.
1. Remove the existing light fixture.
2. Loosely attach the mounting screws into the junction
box mounting holes.
2
Light Fixture Base
Light Fixture Cover
Decorative Nut
Junction Box
Mounting Screw
209987-01

Publicité

Table des Matières
loading

Table des Matières