Siemens SIPROTEC 4 7XT71 Mode D'emploi page 20

✧ Screw the 2 Z-angles included in the delivery to the upper and lower part of the
front cover using 2 M4 screws, respectively.
To do so, insert the screws into the bores on the front cover and screw the
angles tight. The 2 bores on the small side of the Z-angles have M4 threads.
Fig. 8-2
✧ Push the two cover caps back into the front cover (see figure 8-1).
✧ Use 4 screws to fasten the device to the switch panel.
NOTE
Observe the dimensions and notes in Chapter 7.1.
✧ Wire the device as described in Chapter 8.4.
The terminal strip is accessible from the front for this type of assembly.
18
Attaching the Z-angles to the front cover
SIPROTEC 4, Injection Unit 7XT71, Product Information
C53000-B1175-C128-1, Edition 01.2014