Honda FJ500 Manuel De L'utilisateur page 45

1. Changing oil
Change the oil when the engine is warm to assure rapid and complete draining.
1. Place a suitable container below the engine to catch the used oil, and then
remove the oil filler cap, drain bolt, and sealing washer.
2. Tilt the tiller slightly forward and allow all of the oil to drain.
3. Allow the used oil to drain completely, and then reinstall the drain bolt with a
new sealing washer. Tighten the bolt securely.
TORQUE: 18 N∙m (1.8 kgf∙m, 13 lbf∙ft)
4. Refill with the recommended oil (see page 16) to the upper limit.
5. Reinstall the oil filler cap securely.
Oil capacity: 0.58 L (0.61 US qt, 0.51 lmp qt)
DRAIN BOLT
SEALING WASHER
(Replace)
Wash your hands with soap and water after handling used oil.
NOTE:
Please dispose of used motor oil in a manner that is compatible with the
environment. We suggest you take it in a sealed container to your local service
station for reclamation. Do not throw it in the trash or pour it on the ground.
42
OIL FILLER CAP
UPPER LIMIT
LOWER LIMIT