Philips HR2375 Guide D'utilisation page 10

ENGLISH
12
Problem
The safety switch is
triggered and the
appliance suddenly
stopped or suddenly
restarts during the
processing.
During processing,
the appliance stops
working when you
open the lid.
During processing,
the appliance stops.
There is no alarm
sound or flashes.
Small amount of
water is leaking out
from the appliance.
E1 displays on the
screen.
The appliance stops
during processing,
E2 displays on the
screen, the indicators
are flashing quickly,
and the alarm
sounds.
EEE displays on the
screen.
Cause
The front panel knob is
loose.
Excessive ingredients in
the pasta maker.
For safety reasons,
the appliance always
stops working when
the lid is opened during
processing.
The pasta maker has
overheated due to long
continuous working
time.
Water is added before
the program starts.
The shaping disc is not
attached.
The lid is not in place or
not properly attached.
The mixing paddle may
be blocked by some
foreign objects.
The dough may be too
dry.
The wrong program is
selected.
The appliance
malfunctions.
Solution
Make sure the front panel is securely
assembled.
The maximum amount of flour used
for each batch is 500g. If more than
500g is added, reduce the amount of
flour before next batch.
If you need to resume the previous
operation, close the lid properly, and
press the Start/pause button.
Disconnect from the power source,
and allow the pasta maker to cool
down. To better protect the lifetime
of the appliance, the continuous
working time should be less than 45
minutes. You can restart using the
appliance after 15 minutes of rest.
Follow the user manual instructions
to add water right after the program
starts.
Attach the disc holder to the main
unit, attach the shaping disc properly
and fix the front panel properly to
the device.
Attach the lid properly.
Disconnect from the power source,
clean the pasta maker, and follow
the user manual again to restart the
pasta making.
Contact the service center.