Rolsen RL-15X11 Manuel Du Propriétaire page 29

2 2
PC Setup
You can adjust horizontal/vertical position, clock, phase,
and auto-configure, reset as you prefer.
D
Press the MENU button and then
the SETUP menu.
G D
Press the button and then /
desired picture item.
F G
Press the / button to make appropriate adjustments.
H-Position / V-Position
This function is to adjust picture to left/right and up/down
as you prefer.
Clock
This function is to minimize any vertical bars or stripes vis-
ible on the screen background. And the horizontal screen
size will also change.
VGA mode
When the set is inputted 480p signal in VGA mode, select 480P on the SETUP menu.
SETUP SETUP
Language Language
CSM CSM
PC Control
PC Control PC Control
VGA Mode VGA Mode
()}{OOOKOOMENUOOEXIT ()}{OOOKOOMENUOOEXIT
Phase
This function allows you to remove any horizontal noise
and clear or sharpen the image of characters.
E
/ button to select
Auto-configure
This function is for the automatic adjustment of the screen
E
button to select the
position, clock and phase. The displayed image will disap-
pear for a few seconds while the Auto-configuration is in
progress.
Reset
This function allows you to return to the good picture repro-
duction programmed at the factory and cannot be
changed.
Note : Some signal from some graphics boards may not
function properly. If the results are unsatisfactory, adjust
your monitor's position, clock and phase manually.
Press the OK button to store it for the PC monitor picture.
Press the EXIT button to return to PC mode.
H-Pos. 5
V-Pos. 100
Clock 50
Phase 15
Auto
Reset
SETUP
Language
640x480
CSM 480P
PC Control
VGA Mode
VGA Mode
()}{OOOKOOMENUOOEXIT
EN
29