Rolsen RL-15X11 Manuel Du Propriétaire page 23

4 4
Stereo/Dual/NICAM reception
In AV mode, you can select output sound for the
left and right loudspeakers.
Repeatedly press the I/II button to select the sound
output.
L+R :Audio signal from audio L input is sent to left
loud-speaker and audio signal from audio R input
is sent to right loudspeaker.
L+L : Audio signal from audio L input is sent to left
and right loudspeakers.
R+R : Audio signal from audio R input is sent to left
and right loud-speakers.
Mono sound selection
In stereo reception if the stereo signal is weak, you
can switch to mono by pressing the I/II button
twice. In mono reception the depth of sound is
improved. To switch back to stereo, press the I/II
button twice again.
Language selection for dual language broadcast
If a programme received in two languages (dual language), you
can switch to DUAL I , DUAL II or DUAL I+II
button repeatedly.
DUAL I sends the primary broadcast language to the loudspeak-
ers.
DUAL II sends the secondary broadcast language to the loud-
speakers.
DUAL I+II sends a separate language to each loudspeaker.
If your set is equipped with the receiver for NICAM reception, the
high quality NICAM (Near Instantaneous Companding Audio
Multiplex) digital sound can be received.
Sound output can be selected according to the type of received
broadcast as follows by pressing the I/II button repeatedly.
When NICAM mono is received, you can select
or FM MONO.
When NICAM stereo is received, you can select
STEREO or FM MONO. If the stereo signal is weak, switch to FM
mono.
When NICAM dual is received, you can select
NICAM DUAL II or NICAM DUAL I+II
mono is selected the display MONO
by pressing the I/II
NICAM MONO
NICAM
NICAM DUAL I ,
or MONO . When FM
appears on the screen.
EN
23