LGB VT 133 Instructions De Service page 14

The following registers can be configured:
Register Function
CV1 Loco address With LGB Multi-Train System
CV2 Starting voltage
Voltage for speed setting 1 - if loco only starts at a higher
speed setting, increase value.
CV3 Acceleration
Acceleration (1 = fast, 255 = slow)
CV4 Braking
1 = fast, 255 = slow
CV5 Maximum track voltage
Voltage for highest speed step - if a lower top speed is
desired, decrease value.
CV5 Function value for CV to be programmed after input of
(when programming with older 55015)
CV6 CV to be programmed (when programming with older 55015)
CV29 NMRA configuration
Bit configuration
Bit 1: direction of travel, 0 = normal, 1 = reversed [0]
Bit 2: speed steps, 0 = 14 (LGB), 2 = 28 [0]
Bit 3: analog operation, 0 = not possible, 4 = possible [4]
Bit 4: not assigned [0]
Bit 5: speed steps table, 0 = factory-programmed,
16 = user-programmed [0]
Bit 6: address area, 0 = 0-127 (LGB), 32 = 128-10039 [0]
To program, add the values for the individual bits and program
the resulting function value. Note: To program a loco to
reversed direction of travel (e.g. F7 A-B-A combination),
program function value 5.
Attention! Loco addresses 128-10039 and 28 speed steps
cannot be used with LGB MTS.
CV49 Voltage for function terminal F1
(depends on loco model, do not change, as functions can
be affected or destroyed)
CV50 Voltage for lighting terminals (see CV49)
CV51 Command key for function terminal F1
0 = lighting button 9
1 = button 1 (buttons 2-8 not assigned)
9 = button 1 (buttons 2-8 also assigned)
10 = button 2
11 = button 3
12 = button 4
13 = button 5
14 = button 6
15 = button 7
16 = button 8
64 = lighting button 9 (ON only when loco is reversing)
65 = button 1 (ON only when loco is reversing)
16
Available Factory
values pre-setting
(00-22) [3]
(0-255) [2]
(1-255) [3]
(1-255) [3]
(1-255) [255]
CV6
[4]
(1-32) [5]
(1-32) [5]