Publicité
Les langues disponibles
Les langues disponibles
LGB remote control units are
required for the following functions.
Function:
Pressing the appropriate key triggers
the functions listed below.
Function keys:
1 Interior lighting
Note:
Function key assignment can be cus-
tomized.4
Lighting key:
9 Lighting off/on
Data transmission (serial)
With older MTS components, com-
mands are transmitted as a sequence
of single commands (e.g. 3 =
1+1+1).
However, most MTS components
can be upgraded to parallel function
commands.
Exceptions:
- First generation 55000 MTS
Central Station and
- 55010 Train Mouse.
Note:
Further information can be obtained
from your authorized retailer.
Data transmission (parallel)
When using MTS components
marked with a "P", the loco can
receive "parallel" function com-
mands, which eliminate the pause
that occurs when a "serial" command
is received.
Programming
Numerous functions of the onboard
decoders can be configured, e.g.
14
- Acceleration
- braking response
- direction of travel
- and many more.4
The decoder can either be configured
using
the
55045
Programming Module or the 55015
MTS Universal Remote Control
Unit.4
SERVICE
Do-it-yourself service levels
Beginner
Intermediate
Advanced
Improper service will void your war-
ranty.
Note:
For quality service, contact your
authorized retailer or an LGB factory
service station (see Authorized
Service).
Lubrication
- Lubricate the axle bearings with a
drop of LGB-oil every now and
then.
Cleaning
- This model can be cleaned exter-
nally using a mild detergent and
gentle stream of water.
Do not immerse this model in the
detergent.
Replacing the light bulbs
Lights (front/rear):
We recommend to have these com-
ponents exchanged by an authorized
repair shop. For quality service, con-
tact your authorized retailer or an
LGB factory service station (see
Authorized Service).
MTS-PC
Publicité
