Memorization Of Remote Controls; Deleting Remote Controls - V2 AZIMUT Mode D'emploi

9 9 . . E E n n d d p p r r o o g g r r a a m m m m i i n n g g
Per uscire dalla fase di programmazione e memorizzare le impostazioni dei vari parametri è necessario seguire la procedura che segue.
I
+
Press the + key until the display
I I
shows
MEMORISING REMOTE CONTROL UNITS
The device can memorise up to 15 remote control units. To memorise a remote control unit, proceed as follows:
+
Press the key
PLEASE NOTE: To select the button to be used to control the automation system, please refer to section "5. Selecting the
remote control button"
DELETING REMOTE CONTROL UNITS
+
Press and hold key
-
Press and hold the
-
The dot appears on the display
-
The dot on the display lights up
:
after approx. 1 second
I
+
-
key for 5
I I
seconds: flashes
0
+
-
0
+
-
23
0
+
-
Release the key: the segments of
the display illuminate one at a time
0 0
until showing
0
+
-
Release the key and press the
remote control button twice: the
device emits a BEEP and the dot is
turned off to confirm memorising
has been successful
0
+
-
Hold the key until the dot on the
display is turned off the remote
controls have been deleted.