Set-Up Of Operational Parameters - V2 AZIMUT Mode D'emploi

SET-UP OF OPERATIONAL PARAMETERS

AZIMUT is equipped with a practical interface that allows rapid and simple on-display programming
using four keys: , , +, -.
Preliminary operations:
1. Move the door so as to hook on the drive trolley.
2. Power up the device: the courtesy light comes on, the control unit emits a BEEP and the segments
of the display are illuminated one at a time until the display shows
PLEASE NOTE: if programming is not completed (by means of function 9. End programming) the parameters set are lost.
If there is an error in the set parameters, simply power off the device, restore power and then repeat the programming
operation.
1 1 . . S S e e t t t t i i n n g g t t h h e e o o p p e e n n l l i i m m i i t t s s w w i i t t c c h h
0
+
Press the key for 5 seconds.
I
+
+ -
Press and hold the or key to
reach the fully open position
PLEASE NOTE: The open limit switch must be stored prior to the close limit switch. If this procedure is used erroneously to
set the close limit switch, the parameter is NOT stored.
2 2 . . S S e e t t t t i i n n g g t t h h e e c c l l o o s s e e l l i i m m i i t t s s w w i i t t c c h h
2
+
-
Press the key,
2 2
the display shows
2
+
- +
Press and hold the or key to
reach the fully open position
-
The device emits a beep and the
-
-
-
0 0
.
I
+
-
I I
display shows
The door opens
The door closes
2
+
-
Press the key:
2 2
flashes
The door closes
The door opens
19
0
+
-
I
+
-
Press the key:
I I
flashes
I
+
-
When the door reaches the desired
position, press the key to save
the settings
2
+
-
When the door reaches the closed
position, wait 2 seconds, then press
the key to save the settings