Ferroli EGEA 200 LT Manuel D'utilisation, Installation Et Entretien page 102

OUT
IN
fig. 17- Example of water system
Legend (fig. 17)
1 Water inlet pipe
4 Recirculation water inlet
5 Hot water outlet pipe
9 Inspectionable end of dis-
charge pipe
10 Pressure gauge
11 Shut-off valve
12 Pressure regulator
EN
102
EGEA
13 Safety valve
14 Expansion vessel
15 Drain tap
16 Recirculation pump
17 Spring check valve
18 Automatic thermostat mix-
ing equipment
cod. 3541T600 - Rev. 08 - 12/2021
200 LT - 260 LT - 200 LT-S - 260 LT-S
6.6.1 Condensate drain connection
The condensate forming during heat pump operation flows
through a special drain pipe (1/2"G) that passes inside the insu-
lating casing and comes out at the side of the equipment.
It must be connected, via a trap, to a duct so that the conden-
sate can flow regularly (fig. 18).
fig. 18- Examples of condensate drain connection via a trap